Description

• The 6.08 screens in the kit will soon be changed to the new version of the screens. ChiTu 6.08″ 2k Mono LCD Screen PJ608-X04 For Elegoo mars 2 pro / Voxelab Proxima 3d printers. This screen requires to work properly compared to the previous DXQ608-x04. *Note* This screen has a higher transmittance than the previous DXQ-608 mono screen. The exposure time needs to be reduced when printing. The parameters we have tested are 2s Exposure Time and 25s Bottom Exposure Time. If you have any other questions about installing the screen, you can check or contact our technical colleagues support@cbd-3d.com Why upgrade? The Creality LD002R comes with the Sharp04 screen, which is 5.5 inches 2K RGB LCD, 2018 there are Mono LCD coming out, and it is been widely used during 2019, Phrozen sonic Mini, Anycubic Photon mono series, and ELEGOO mars 2 series. we also write an article about RGB vs Mono, you can check . Now, most new resin 3d printers come with Mono screens, and even with 8K level resolutions. In General, the Mono screen has 3 advantages compared with the RGB LCD. Faster printing speed The mono LCD has a better UV light transmittance, which means when you use the same resin, it takes less time to make it cure, and in the Chitubox setting, you will only need an exposure time of around 2.5s. In RGB LCD, the exposure time is about 8s~12s. Each layer saves you a few seconds. If you are printing a large file, it is much faster. More durable in lifespan The mono LCD has a process optimization, which makes the screen can run in the long term under the UV light, it is suspected to work over 2,000 hours. and the RGB LCD can only work about 200 hours. Better contrast ratio The mono screen is designed for 3d printers, it also considers the usage of 3d printing technology, a better contrast ratio means you will get better details on the models, especially in sharpness . For CREALITY LD002R: The original LD002R comes with the Sharp04 screen, which is a 5.5 inch RGN LCD, and our solution is almost a plug and plays kit to make your LD002R to be an LD002H. Adjust the settings on CHITUBOX You can use the setting of LD002H profile directly after upgrading this kit, The actual printing size will be bigger than 5.5 inches but not reach 6.08inch after modifying, please use this setting below.

• 
• 

Review