Preces apraksts

•   Features:1. Open the plastic nozzle with a needle drill. Do no longer get close to the face when coming into the nozzle, and don't pull an excessive amount of or squeeze the tube.2. Firstly, Remove oil, water, rust and paint from the gasket surface, and the gasket surface should be consistent.3. When in use, just need to squeeze a small quantity of sturdy glue on one facet of the seam surface and then press the other side, which might be firmly bonded in 11 to twenty seconds. The glue does not deserve to disperse evenly, and don't squeeze an excessive amount of glue, too much glue will impression the bonding effect.4. After use, wipe off the surplus glue on the peak of the examine tube with a dry cloth, after which shut the bottle cap.     Attention points:Beware of glue dripping in the eyes and splashing in the entrance!Do no longer enable teenagers to touch it, to bypass danger!Pay consideration to sticking to pores and skin and fingers!It is strictly forbidden to show to the sun and sizzling places, please hold it in the shade! It is not necessary to spread the glue evenly, do not extrude too much glue, excess will influence the bonding effect.The polymers within the glue rely upon the tensile strength of each other to bind the two gadgets firmly together. In the use of glue, too much glue will cause the polymers within the glue to crowd every single other.There is no good stress between the polymers. The polymers are so tightly bonded together that they do not type the most powerful charm to each other. At the same time, the water between the polymers isn't always clean to volatilize.That is why in the bonding process, "The thicker the film, the worse the felt effect of the glue." If you observe an excessive amount of glue, the glue may be filled.

• 
• 
• 
• 
• 

Atsauksmes