विवरण

• ATU-100： We use the best raw materials For example, we use T68-2 imported low-heat and low-loss magnetic ring (imported red-brown) Note: The darkish crimson is a magnetic ring made in China Buyers please eavesdrop on distinguish the difference between magnetic rings C channel capacitors are all 2KV high voltage capacitors Because we use the best raw materials, we will ensure that the standing wave ratio should not very excessive during use and could be used normally and efficiently throughout transmission NOTE: Recommended maximum energy whereas tuning no longer above 30 watts (after tuning you could set 100 watts and work in this power) Description of firmware program and Accessories: 1 current firmware edition is 3： （1）SWR greater than 1 will robotically activate tuning, and the minimum strength has been changed from 5W to 1W 3 Program would be tuned below 5W However, Too low value may result in insufficiently superb tuning (original default is bigger than 5W auto tuning) , please know before putting an order （2）Fixed computer virus with continuous information transfer to the display （3）Added a new capacity to disable all relays together with the timer demonstrate New mobile 35-01 to activate the refunction Display Off Timer setup - cell 32 can use this destiny on your QRP setup where power consumption is critical （4）Timeout for exhibit reset elevated to two seconds This is needed for some OLED reveals with a totally chain at the reset pin 2 Accessories: All use Samsung SMD capacitors, C-channel capacitors, we use Samsung 1000V high-voltage SMD capacitors (the customary default uses 500V), and the PIC chip imported from the United States three Description: Power delivery range: 10-15 VDC Max current: 450mA Max working power: one hundred watts Max measured power: a hundred and fifty watts Minimum energy for tuning start: 1 watt Recommended maximum energy whereas tuning no longer above 30 watts (after tuning you can set 100 watts and work on this power) Minimum measured power: 0 watt Step for measurement on powers under 10 watts: zero watt Step for measurement on powers above 10 watts: 1 watt Power dimension accuracy: 10% Maximum inductance set: 8 uH Minimal step for surroundings inductance: zero uH Maximum put in capacity: 1870 pF Minimal step for setting capacity: 10 pF NOTE: 1 kits need to have welding capacity 2 The firmware program has been burned 3 chip resistors had been soldered four schematic and firmware, please touch us 5 of ATU (Automatic Antenna Tuner) developed by means of N7DDC All information about project yow will discover on GitHub (N7DDC) The board has been burned 3 program: Package List: 1 PCB motherboard * 1 (SMD digital elements at the entrance and again were soldered, and the newest edition of the firmware has been burned) 2 Several plug-in digital components and accessories(User welding is required) 3 zero inch OLED screen * 1

• 
• 

समीक्षा