विवरण

• City Power ⇆ Generator EAATS Usage Precautions: 1 220V ATS should not be used with a voltage lower than 185V, in any other case the coil might burn out 2 110V ATS should not be used with a voltage less than 90V, in any other case the coil may burn out 3 The change cannot be manually switched when in computerized mode, in any other case the coil could burn out 3 4P ATS ensure correct connection of section sequence,otherwise the contacts may burn out General EATTS-F-CG-63 automated move swap is a PC category infrequent change-over switch, with two-station design (commonly used for A and standby for B), suitable for AC techniques with AC 50-60hz and rated latest 10A-63A The leading operate of the automated move change is when the main energy (common power supply A) fails, the ATS will routinely swap to the backup energy (Backup power supply B) to continue working (switching pace <50 milliseconds), which may efficiently solve the troubles brought on by power outages When either A and B have electricity, priority is using A Power NOTE: 1 Manual/automatic operation can ensure the opening and closing performance of electric operation, but in handbook operation , there's no guarantee due to the different _opening/closing speeds of the operators In manual operation, there&;s probable for immoderate silver alloy loss Therefore, the selector swap should only be pulled to the manual position after all strength has been cut off for inspection and maintenance of the working formula and get in touch with information 2, Normally, pull the selector change to the electric position When guide operation is required, pull the selector switch to the guide position After handbook operation is complete, pull the selector switch from the guide role to the automatic function The management circuit TSE is immediately energized After the exchange over is completed, the internal change will injury the coil within the control circuit, and the coil can work normally at 85%-110% of the rated working voltage Too low input voltage may cause the coil to overheat and burn out Attention!When guide operation the mode selection switch should be in "manual" function

• 
• 
• 
• 
• 

समीक्षा