विवरण

• Parameters:Product Name: WS2811 IC COB Horse Race Led Strip LED Type: COB LED Diodes LED Qty: 360LEDs/M PCB width:10mm Max Power: 10-12W/M Working Voltage: DC 24V Color: Cool White / Warm White / Natural White Color Temperature: Cool White 6000K / Warm White 3000K / Natural White 4000K IP Rate: IP20 Non-waterproof Connector: three Pin Male Female Connector Package: 5M/Roll Connection: Red Wire: +24V Green Wire:DI/DATA White/Black wire: GND / -24V *** Product Parameters of the Controller: Product Name: Single Color Horse Race Led Strip Controller Working Voltage: DC24V ( The controller dont connect with the power supply) Control Distance: < 20m Battery Type: CR2032 button cellular ( Not included) Modes: 26 Different modes included controller. With Switch Function ( Green Wire hook up with a common switch): Turn ON,the lighting running, Turn OFF, the lights backflow. Max Pixel Control:Max Control Pixels: 3200pcs Pixels,if greater than 3200pcs pixels,just add extra receiver or amplifier to attain sync working. Installation: With 2pcs double-side tape,anywhere to stick. 3Keys Remote Function: ON/OFF, Model Key, Brightness UP/Down,Speed UP/Down *** Features: 1. one receiver could be managed by way of max 6pcs 3keys panel remotes. 2. Two or extra receivers could be linked together,realize sync working. The wire between two receiver would be as much as max 10metes for extension. Best desire for tasks sync working. 3. The controller can be work with common switch, Turn ON/OFF by way of method of the switch with out remote can also connect with Mihome Smart Switch to realize voice control. *** Sync Projects: Wire Connection Sync Working: 99% sync(Recommend) Wireless connection sync working: Maybe has put off *** How to pair Remote to the Receiver,make them working independently ? Step 1: Turn at the calories supply. Step 2: Long press "Mode"keys 3seconds inside 2 seconds after powering ON. Step 3: Sucessfully if the led strip quick flash three times. 1pc receiver would be managed via max 6pcs panel remote. - IF you led strip only 10-12m working,please do "pixel setting" on the remote. NOT quality problem. *** How to environment pixels? Step 1: Turn OFF the lights Step 2: Long press "Mode" keys five seconds,press "Speed" keys to extend the pixels quantity, Press "Mode" keys to diminish the pixels quantity. Step 3: Press " ON/OFF" to save, Exit. Default manufacturing facility surroundings is 80pixels,max as a lot as 3200pixels. If you found some led strip is not light, please kindly do pixel setting as above steps. IF Your Led strip is flickering, this is Not quality problem. Just join all led strip to the ability transport in case of voltage-drop as following photograph shows:

• 
• 
• 
• 
• 

समीक्षा