説明

• Food Waste Disposal â– Snap design is easy to install, splash-proof and silent â– No blade grinding + deep double layer shredding, safe and more effective â– Pure copper motor with German imported technology, stronger energy â– Overload protection + high temperature protection, longer lifestyles â– Daily use, a month of electricity intake of about 2kWh, ultra-low calories consumption Easy Disposal of Many Types of Food Waste The meals waste disposer can manage 95% of meals waste similar to culmination and vegetables, fruit peels and shells, small bones, small ribs, seafood fish bones, small shells, and so forth Cannot handle: plastic bags, hair, huge bones, vast shells and non-food waste One Click - So Easy Operation steps 1 Turn at the water tap 2 Start the processor with one button 3 Pour the meals waste into the grinding chamber 4*Please note: After watching for the food to be completely ground, continue to maintain the tap on and keep it on for 5 seconds and then flip it off 5 The mechanical device is set with overload defense device, exceeding a undeniable load or overheating, the mechanical device will mechanically close down Blade Free Grinding System No blade grinding to realize high-speed rotating impression for a number of cutting and grinding, fantastic filtering of food residues Safety & Environment Adopt German permanent magnet motor, provide powerful grinding power, can load 1000ml at a time understand low energy consumption, save time and gear and safer! Thickened Feed Silicone Cover Weaken the noise and prevent the residue from spattering when grinding Suitable Size This machine is acceptable for a sink opening of 110mm in size, whereas its button for the air switch is suitable for a 3cm mounting gap Product Q & A Q: How can I set up the mechanical device if the sink diameter is not 11cm? A: The machine is suitable for sink diameter of 11cm, if the sink diameter isn't always suitable, we propose you should use reducer (reducer ring) to change the sink diameter Q: How huge is the opening of the air switch? A: It is usually recommended that the diameter of the hole within the counter height or wall is 2~3cm Q: Is the machine easy to install? A: It is very easy to install, set up requires some pressure We simulate the set up steps within the product video, presently greater than 99% of buyers can perceive the installation steps during the video and instructions, if you find it very difficult, it is suggested to ask a professional for set up Q: Is the stone sink compatible for installing the machine? A: It is suggested to judge by way of the thickness of the sink bottom, if the bottom thickness is 10mm (1cm) or less, it's probable to put in the mechanical device It is recommended to polish the stone sink mouth tender earlier than installing the machine Q: How can I examine if the mechanical device is operating properly after I get hold of it? A: Please set up the air switch of the machine, then plug within the power and press the button, the mechanical device can start or close down usually Q: I obtained a new machine and found that there are scratches contained in the grinding disc, how can I do? A: The product is inspected on the factory, powered on and the mechanical device is began Therefore, the grinding disc left operating traces, this can be a typical situation, consumers can set up and use the mechanical device normally, please don't worry Q: What must I do if the mechanical device is stuck? A: A jammed state suggests that the machine has activated the electrical defense function Please cut off the flexibility and clear all of the residues and overseas gadgets in the grinding chamber (especially the edge gap), insert and turn the grinding disc with a screwdriver, and eventually press the pink reset change evenly and gear on to activate normally

• 
• 
• 
• 
• 

レビュー