DC 12V‑36V 15A 500W Brushless Motor Controller l BLDC Driver Board
Feature:
1 Operating voltage: DC 12V-36V
2 Operating Current: Specification:
Description:
one hundred pc Brand New & High Quality
Operating voltage: DC 12V-36V
Operating Current: Driver Power: Speed Voltage: 0
Operating Temperature:-40-85°C
Humidity: 90%RH
Stall protection:Yes
Enable Control: Yes
Over-current protection: Yes
Steering control: Yes
Speed management signal: Yes
Size: 63*42*17mm(L*W*H); Probe size 3mm,length: solving gap center distance 57mm; width:fixed gap center distance 36
Power terminal Out:
VCC(positive energy supply)
GND(negative one)
MC(motor levels W)
MB(motor phases V)
MA(motor section U)
Set for the management side:
GND management terminal floor
VR the governor end 0-5V(corresponding to 10% of motor velocity -100%)
ZF reversing control(connected to 5V or floor can the motor rotation direction)
M tachometer pulse output(depending on the number of motor poles such as the variety of pulse in keeping with of the output number)
EL enable control terminal(connected to 5V ot floor operating then 5V, grounding the motor stops)
5V 5V management terminal
L for the l terminals:
5V l energy advantageous
Ha l signal
Hb l sign
Hc l Signal
GND l adverse
Wiring:
Control terminal for SET:
1 The motor velocity control wiring methods: out there potentiometer system velocity is also connected to the MCU control, when the potentiometer control wiring, the potentiometer middle pin is hooked up to VR velocity port, potentiometer connected to both ends of 5V and GND terminal voltage extra excessive pace faster
2 Motor steerage control wiring methods: you could swap control can also be related to the MCU control, to GND in one direction, then in a single route 5V
three Pulse pace signal: high and low output IC cannot understand the data with the customer request
l signal inputs for l:
Wiring diagram is shown, one resembling the HA, HB,HC and at the motor, 5V strength delivery linked to the motor signals positive, GND energy delivery damaging sign to the motor l
Note:
Due to varied motor brands to make the l of l line order would not necessarily keep on with the road at the board to check the sequence, must be adjusted, please parents who pay attention! If the road series wrong, does not boot properly, current, or birth different phenomena not open, compelled to use the drive plate will burn!!!
Motor driving force board 12-36V DC power input, VCC wonderful strength supply,GND energy supply is detrimental
Please notice that the hot form and old sort of this product might be despatched randomly, and ensure you will not mind before ordering
Electrical wiring methods: Brushless DC motor for the 3 lines, corresponding MA/U,MB/V,MC/W
Tips:
If you utilize lower than 60W, with out additional warmth sink , make sure you add more than 60W
heatsink fins power performance with out reducing the temperature is simply too excessive will shine into everlasting damage! The size of the warmth sink could be a bad surroundings based work(recommended cooling surface field more than two hundred sq. centimeters)!When installing the heat sink ,must pay attention to the back of the module 6 MOS pipe insulation, no insulation, it is going to be adhered to drive plate completely damaged! Proposes to add insulation films, each side of the insulating sheet plus thermal grease!
Package Includes:
1 x 12-36V 500W Brushless Motor Controler