説明

• 1: 1 Ultra-low vibration and noise 2 Maximum peak current: 5A three Impulse reaction frequency: 200KHz four Subdivision: 200~51200ppr five Voltage: 16~70VDC 6 Variable current control, motor heating is vastly lowered 7 Protection functions similar to overvoltage, overcurrent, monitoring error out of tolerance, and many others eight Closed-loop vector control to ensure high-speed and high-torque output of the motor, and confirm that the motor does not lose steps nine Signal input: pulse + direction or double pulse (differential), well matched with 5~24V alerts without collection resistance 10 Serial communique function, current, subdivision could be adjusted arbitrarily, signal edge, alarm output logic and different purposes are adjustable 2: HBS57 uses the most recent committed motor control DSP chip and vector closed-loop management know-how to utterly conquer the problem of open-loop stepper motors wasting steps, while tremendously improving motor high-speed performance, reducing motor heating and lowering motor vibration, getting better machine processing velocity and accuracy, and lowering Machine energy consumption When the motor is always overloaded, the driving force will output an alarm sign in time, which has an analogous reliability as the AC servo system HBS57 is customized to fifty seven sequence closed-loop stepper motors, which facilitates the upgrade of typical stepping method solutions, and the cost is simply 50% of the AC servo formula 3: The cable connecting HBS57 to the PC, text exhibit or STU servo debugger ought to be a dedicated cable (purchase required) Please verify before use to bypass injury four indication The green LED is the ability indicator When the power is powered on, the LED is often on; when the power is powered off, the LED is off The pink LED is a fault indicator When a fault occurs, the indicator flashes in a cycle of 5 seconds; when the fault is cleared by the user, the crimson LED is always off The flashing frequency of the pink LED is 2Hz, the place the LED is on for 200ms and off for 300ms the power fails, the power will stop and prompt the corresponding fault code The fault can be cleared solely when the user needs to strength off and gear on back When the force fails, the power will store the latest faults in the drive&;s EEPROM in a queue format, and the pressure can store as much as 10 latest historical faults The consumer can learn the corresponding fault code throughout the PC and text demonstrate 5 sign port Name description PUL＋/PUL－: Pulse enter signal: The high-quality edge of the heart beat is adjustable, and the default pulse rising edge is effective; in an effort to respond reliably to the heart beat signal, the pulse width needs to be greater than 1μs 5~24VDC level compatible In double pulse mode: CW DIR＋/DIR－: Direction input signal: high/low level signal To ensure dependable commutation of the motor, the path signal needs to be established at the least 5μs before the pulse sign 5~24VDC point compatible In double pulse mode: CCW ENA＋/ENA－: Enable control signal, this enter signal is used to enable or disable driving force output When ENA is attached to low point (or the internal optocoupler is became on), the force will cut off the present of every section of the motor in order that the motor is in a loose state and would not reply to input sign pulses When this operate isn't always needed, the allow signal terminal could be left floating 5~24VDC point well matched Pend＋/Pend－: signal output in place, open-collector form, pull-up resistor must be used when utilizing 5V\12V\24V separately 0\1K\2K resistance (this sign could be extended and used, after the driver conceal is opened, there's a reserved socket) ALM＋/ALM－: fault signal output, in the sort of open collector, should use pull-up resistor 5V\12V\24V to apply individually 0\1K\2K resistance, fault output logic can be set by PC utility

• 
• 
• 
• 
• 

レビュー