説明

• How to apply our wallpaper? STEP 1: Prepare the wall floor Your wall must be permanently flat, clear and dry Levels tough surfaces, rough, holes and uneven spots Your wall must be a uniform color If not, you may word differences in colour on your wall as soon as put in If your wall has multiple colors, we recommend that you just paint again Make a vertical line with a plumb line on the left fringe of the realm you desire to disguise with the mural If you've a plumb, one can make your personal by means of tying a heavy object at the end of a rope This line is significant because it is the instruction manual to start placing your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of 48 cm(19") Panels are acquired published always on a roll and numbered on the peak Cut self reliant panels and do a preview on the ground following the numerical order from left to appropriate Measure with a meter the peak of your wall If it&;s lower than the photomural, it is best to lower it to fit correctly Do it whenever you have it at the floor but depart a margin of an inch to correct any variations in level at the wall STEP 3: Prepare the glue You could buy the glue from your supermarket, confirm it&;s for non-woven wallpaper use Prepare the glue following the directions on the bag of the glue you obtain Do it slowly So you will achieve a uniform combination and without bubbles STEP 4: Attach the paper to the wall Applying glue on the wall lightly utilizing a brush or a paint curler Start distributing from the line you marked as a handbook to the plummet Don&;t paste the complete wall, do it only within the field that will hide the 1st panel on the left, leaving about a inches outdoors the proper Apply the 1st panel of the mural on the wall starting at the peak left Check that's aligned with the instruction manual Presses against the paper with a dry curler or sponge to take away any air bubbles Place the following panels in the same manner in numerical order The panels mustn't ever be fastened on one another yet are set on edge Clean the excess glue with a moist sponge STEP 5: Finishing With assistance from a ruler and a cutter, adjust the edges and the tip and backside of the wall if mandatory Let dry 24 hours; you'll get an ideal final result

• 
• 
• 
• 
• 

レビュー