Tu tagad redzi preces, kas tiek piegādātas uz United States. Lai redzētu preces, kas tiek piegādas uz citām valstīm, izvēlies atbilstošu piegādes reģionu.
Momentary -------------
Press button"Up", the Motor Forward, Release is Stop
Press Button "Down", the Motor Reverse, Release is Stop
Latched------------------
Press button "Up", the Motor Forward, Press Button "Stop" is quit
Press Button "Up", the Motor Reverse, Press Button"Stop" is stop
DC12V Motor Forwards Reverse Up Down Stop Controller
A: Working Voltage: DC12V
Max Load: 40A Relay have higher load lower than 400W
Size: 115*95*40mm
Control Type: Up Down Button replace the receiver Output + - position When motor is stop, the Output is 0V
Encoding Type--------------- Learning Button to add Transmitter
Power off then Power ON again , the receiver is still off ,
Receiver with the Power LED indicator
Working Mode: Momentary Latched adjusted via Toggle Switches
“Latched Mode" -----------have the 3s Delay for defense
Momentary---------Switch flip to“M"
Latched-------------Switch turn to " L"
How to Wire on your External Manual Button
Forwards ---------S2 Connect GND
Reverse ----------S1 Connect GND
Stop---------------Stop Connect GND
Limited Switch use NO and COM Terminal (Limited Switch is not incorporated )
Limited Switch Terminal Voltage :DC9V-11V
you can use the limited change with the working voltage
resembling Sensor Switch Switch ,Photoelectric Switch or Mechanical Limit Switch
Lmited Switch Type:
The Controller use usually open type limit switch Forwards Reverse limit are in parallel The function like the stop button of the remote control When achieving the obstacle it's going to work like you urgent the remote control stop button , if the obstacle is removed The motor won't proceed to move forward, it is best to press the handheld remote control down button or the up button to restart
Limit connection:
The Up Limit Switch NO and the Down Limit Switch NO either are cord to our receiver NO Terminal
The Up Limit Switch COM and the Down Limit Switch COM either are wire to our receiver COM Terminal