说明

• Features: Description: l 1. Remove the screws that fix the resin bucket on the side where you want to install the drip stand l 2. Fix the drip holder as a whole to the thread, and then tighten the thumb screw again l 3. During the printing process, the drip tray cannot touch your bottom plate l 4. After printing, move up the build platform l 5. Remove the platform and hang it on the bracket l 6. The uncured resin will drip back into your trough l 7. You can close the lid as needed Specification: l Size: length about 50mm, width about 20mm, height about 55mm l Applicable models: Phrozen Sonic Mini, Most other 5.5″ / 6″ LCD 3D Printers where the resin vat is secured with thumbscrews Packing includes: l 1 x Resin Drip Stand Note: l Not applicable models: all models of Anycubic (the printing platform is different) Thank you for your attention, if you want buy more than we listed, please contact us.we will be ready to reply you ASAP.

• 
• 
• 
• 
• 

审核