Beschreibung

• Introduction: The DRV8825 stepper motor motive force provider is a breakout board for TI's DRV8825 microstepping bipolar stepper motor driver The module has a pinout and interface which are practically similar to those of our A4988 stepper motor motive force carriers, so it may be used as a higher-performance drop-in substitute for these forums in lots of purposes The DRV8825 features adjustable current limiting, overcurrent and overtemperature protection, and six microstep resolutions (down to 1/32-step) It operates from eight - forty five V and might bring up to roughly 1 A in line with part with out a heat sink or compelled air flow (rated for as much as 2 A in step with coil with ample further cooling) Features: Simple step and path management interface Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step Can interface directly with three V and 5 V programs Over-temperature thermal shutdown, over-current shutdown, and under-voltage lockout Short-to-ground and shorted-load protection 4-layer, 2 oz. copper PCB for advanced heat dissipation Exposed solderable floor pad below the driving force IC on the backside of the PCB Module size, pinout, and interface event these of our A4988 stepper motor driving force carriers in maximum respects (see the bottom of this page for more information) Adjustable current control lets you set the utmost latest output with a potentiometer, which permits you to use voltages above your stepper motor's rated voltage to attain larger step rates Intelligent slicing control that mechanically selects the right current decay mode (fast decay or gradual decay) 45 V maximum delivery voltage Built-in regulator (no exterior good judgment voltage supply needed)

• 

Rückmeldung