Description

• Product Name: 0.3M Reduction Metal Copper Gear Plastic Pinion   Material: Plastic/Copper   Modulus: 0.3   Gear Diameter = (Number of Teeth + 2) x Modulus   71A: 7 Teeth, Bore 0.95mm, Brass Gear (fits motor shaft of 1mm diameter), Diameter 3mm   702A: 70 Teeth, Bore 1.95mm, Plastic Gear (fits motor shaft of 2mm diameter), Diameter 21.6mm   701A: 70 Teeth, Bore 0.95mm, Plastic Gear (fits motor shaft of 1mm diameter), Diameter 21.6mm   Installation Tips:   (1) When putting in this pinion, be sure you press the rear conceal of the hole cup motor to bypass accidents the place the motor disguise is jacked out by means of the shaft; because the hole is small, there is a possibility that too much power could cause the tools to fly out, so be sure you discover an open and clear place with little debris for installation, so that even though the tools flies, it may be retrieved.   (2) When installing the copper equipment (tight-fitting type), you might gently faucet the again disguise of the motor whereas holding it opposed to the back cover.   Pack Quantity: 1Pcs ​ ​ ​  

• 
• 

Review