DescriptionReport ItemSuper flat cord Can be used at the wall floor or ceiling, used for hidden speaker wires with out passing through the wall for domestic theater, car audio and other low-voltage package connection Less than 36V paintable surface comparable to white overlaying tape makes the thread clean to hide our video for the entire installation instruction manual greatest issue in establishing a home theater is figuring the place to run the wires When tearing up your wall is not an choice you're often left with unsightly, messy shopping wiring around the edge of the room Flat wire offers you flat neat twine runs on your floor, walls, or ceiling, giving your set up a clean, elegant look with out drilling any holes Peel back and trim adhesive backing to expose about 1" of the adhesive bottom side of the Flat Wire2 Cut around exposed conductors and take away backing Separate White Backing from the topside of the conductors in an effort to divulge a clear copper floor Place eliminated White backing at the backside side- the adhesive side- of the conductor (See Video)4 Clean off any ultimate adhesive on the top facet of the conductor utilizing rubbing alcohol or another solvent Trim off tips of conductors so you have a nice clean conductor tip Slide conductors into clips on the terminal block then snap terminal block close Instructions1 Clean floor VERY WELL with soap and water when possible FROGBRO as proven above Allow somewhat extra size in case of disorders Test FROGBRO with speakers to ensure that there are not any disorders Starting from one end, expose adhesive and observe Flat Wire, urgent firmly alongside center and edges of Flat Wire as you pass Connect your audio system and enjoy your new setup, Paintable Backing Blends in to WallAdhesive Backing Keeps Ghost Speaker Wire Firmly in PlaceEasy Connections with Included Terminal Blocks23 AWG Conductors
Termination Instructions
1 Peel again and trim adhesive backing to reveal about 1" of the adhesive bottom side of the Flat Wire
2 Cut around uncovered conductors and remove backing
three Separate White Backing from the topside of the conductors with a purpose to disclose a clean copper floor Place eliminated White backing on the bottom side- the adhesive side- of the conductor (See Video)
four Clean off any last adhesive at the peak aspect of the conductor utilizing rubbing alcohol or one other solvent
5 Trim off methods of conductors so that you have a pleasant clean conductor tip
6 Slide conductors into clips at the terminal block then snap terminal block close
Installation Instructions
1 Clean surface VERY WELL with cleaning soap and water when possible
2 FrankEver as shown above Allow a little extra size in case of problems
3 Test FrankEver with speakers to make sure that there aren't any problems
four Starting from one end, divulge adhesive and apply Flat Wire, urgent firmly along center and edges of Flat Wire as you cross
five Connect your audio system and enjoy your new setup