Preces apraksts

• Material: 304 stainless-steel Features: anti-aging, moisture-proof, rust-proof, acid-resistant and corrosion-resistant, clean to use Applicable to: electrical power communication, mechanical chemical industry, maritime ship, rail transit, and many others Tooth use steps 1 Measure the length of the bundled object plus about 15cm per week, lower a bit of stainless-steel strip and bend one finish through 1-2cm 2 The twine mouth of the buckle is against the bending route and penetrates into the tie three Make a circle round the object to be bundled, and the opposite end goes through the buckle and leaves a bit 4 Tighten the cable tie with cable tie pliers and bend it in reverse 5 Cut off the cable tie and use a hammer to hammer the buckle ears tightly 6 The set up is complete L variety use steps 1 the length of the bundled object plus about 15cm according to week, reduce a bit of stainless steel strip and bend one finish by means of 1-2cm 2 cord mouth of the buckle is against the bending path and penetrates into the tie three round the object to be bundled, and the other end is going throughout the buckle and leaves a section four the cable tie with cable tie pliers and opposite bend five off the cable tie and tighten the buckle ear with a hammer 6 Screw use steps 1 Measure the size of the bundled object plus about 15cm according to week, reduce a piece of stainless steel strip and bend one end via 1-2cm 2 The cord mouth of the buckle is against the bending path and penetrates into the tie 3 Make a circle around the object to be bundled, and the opposite end goes during the buckle and leaves a bit 4 Tighten the cable tie with cable tie pliers and bend it in opposite 5 Cut off the cable tie and tighten the screw with a wrench 6 The set up is total

• 
• 
• 
• 
• 

Atsauksmes