Preces apraksts

• 1 The dual strength automated swap is a newly advanced miniature household power switch, which is principally used to check whether the major power supply or standby energy supply is common When the traditional strength delivery is abnormal, the standby energy supply starts to paintings immediately, which ensures the continuity, reliability and safety of energy delivery This product is specifically designed for household rail instailation and is specially used for PZ30 distribution field The dual strength automatic swap is suitable for emergency power supply techniques with 50 or 60Hz and rated(L+N) 230VAC has the characteristics of strong constitution reliable conversion, handy set up and maintenance and lengthy carrier life It is extensively used in various occasions the place energy failure cannot be sustained, and might be operated by electrical energy or manually consists of TSE and controller According to lEC60947-6-1,Part 6-1: multifunctional package and switchgear is formulated it may be viewed that ATS is probably the most certified low-voltage switchgear and control device 2 operation time and set up situations 2 Ambient air temperature The most temperature shall now not exceed 40℃, the minimal temperature shall now not be lower than -5℃, and the typical temperature within 24 hours shall now not be higher than 35℃ 2 Altitude The altitude of the set up website should not be larger than 2000m 2 Atmospheric circumstances When the utmost temperature reaches 40℃, the relative humidity of the set up site shouldn't exceed 50%; when the temperature is the minimum temperature -5℃, the relative humidity is higher, for example, the temperature is 25℃, and the relative humidity is 90% Due to the temperature change, particular measures must be taken to contend with the occasional condensation at the surface of the product 2 Pollution grade The pollution grade of ATS conforms to grade 3 specified in IEC60947-6-1 2 Installation category The installation variety of ATS conforms to the category specified in1EC60947-6-1 2 Installation conditions ATS could be installed vertically on top of things cupboard or distribution cupboard sure the installation distance meets the requirements in Figure 1

• 
• 
• 
• 
• 

Atsauksmes