Açıklamalar

• Product parameters: Voltage: 21v/2.0A21V/4.0A 220v/50Hz Power: 800w Spray bottle: 1000ml Working pressure: 0.1-0.2bar Maximum flow rate: 0-1200ml/min Product gross weight: 1.38/1.6KG Size: 310 * 300 * 140mm Aperture 1.0: suitable for aerosol spraying of diluents such as photocatalyst solutions Caliber 1.5/1.8: suitable for paint, topcoat, repair paint, etc Caliber 2.0/2.5: suitable for spraying primer, latex paint and other coatings. Note: Before use, please rotate the suction tube to the direction of the handle (as shown in the above figure). In order to spray more paint on the bottom of the pot, the suction tube is designed to be longer. Installing the spray pot in other directions may cause slight jamming. The suction tube can be removed and installed tightly in the direction of the handle. Maintain a distance of about 30-40 centimeters between the spray gun and the wall during wall spraying be careful: 1. When the spray gun is stationary, the machine should not be placed head up to prevent paint from flowing back into the motor and damaging it. 2.When spraying upwards with the spray gun, do not release the trigger, otherwise paint may flow back into the motor and cause damage to the machine. The machine cannot spray vertically upwards, and the spraying operation can be tilted 45 ° when spraying the top. 3. After the spray gun is sprayed, it should be cleaned in a timely manner to prevent the paint or paint from blocking the spray hole after it dries, extend the service life of the machine, and facilitate the next use Cleaning method: Fill the spray can with clean water and spray for about 30-60 seconds. Be sure to thoroughly spray out any residual dirt inside the valve core until the clean water is sprayed out. Product diagram:

• 
• 
• 
• 
• 

Gözden geçirmek