Açıklamalar

• Specifications Of The Receiver: Model Number : KR3001-4 RF Working Mode: Superheterodyne Reception Modulation Mode: ASK Working Mode: Momentary, Toggle, Latching and Time Delay Mode Input Voltage: DC five ~ 60V RF Frequency: 433MHz Quiescent Current: 5mA Receiving Sensitivity: >97dbm Theoretical remote control distance:>80-100m(The actual distance has losses reckoning on the applying method) Wired Connection Way: Fixed Wiring Pillar Decoding Mode:MCU Software Decoding Specifications Of The Transmitter: Model Number : KT05-4 Operating Frequency: 433MHz Power by 3V Coin Cell Button Battery (Battery integrated ) Material: PVC Button: 2 Buttons Size: 59mm x 28mm x 8mm Operating Voltage: 3V Operating Current: 12mA Transmitting Power: 10mw Modulation Mode: ASK (AM) Encoding Type: Learning Transfers Distance: 20-50 m Operation Introduction: About Working Mode: Momentary: Press the remote button, the relay connects, launch the remote button, the relay disconnects Toggle: Press once the remote button, the relay connects, press the distant button twice, the relay disconnects Latching: Press the distant button A, the relay connects, press the remote button B, the relay disconnect Time Delay Mode: Press the remote control button, the relay connects; Start timing when launch the remote button, the relay disconnect automatically after 5s or 10s or 15s Clearing the Code: Press the Learning Button at the receivers for eight times, the codes might be cleaned After cleansing the code, all of the handheld remote control cannot paintings any further Learning the Code:(Momentary) Press the training key on the receiver as soon as time, it comes into non permanent atmosphere mode Wait for a moment, the LED could be off , it comes into learning state Push the remote button, LED indicator at the receiver board will flash then come off After three seconds, the LED indicator could be on again, learning efficiently Learning the Code: (Toggle) Press the learning key on the receiver two times time, it comes into toggle atmosphere mode Wait for a moment, the LED might be off , it comes into learning state Press the distant button, LED indicator at the receiver board will flash then come off After 3 seconds, the LED indicator will be on again, studying successfully Learning the Code:( Latching) Note: When you choose for latching mode, to be able to be taught extra distant control, it's best to study two diversified button, the 1st time studying is for ON, the second one time learning for OFF For example: Button A = ON, Button B = OFF Press the training key at the receiver triple time, it comes into latching mode Wait for a moment, the LED indicator on the receiver board will flash then come off Press the remote button A LED flash for 5 occasions Press the distant button B LED flash for five times After 3 seconds, the LED indicator can be on again, learning efficiently A = ON, B = OFF

• 
• 
• 
• 

Gözden geçirmek