Açıklamalar

• How to apply our wallpaper? STEP 1: Prepare the wall floor Your wall needs to be permanently flat, clean and dry Levels tough surfaces, rough, holes and choppy spots Your wall needs to be a uniform colour If not, you might word variations in colour in your wall as soon as put in If your wall has multiple colors, we promote that you just paint back Make a vertical line with a plumb line on the left fringe of the realm you want to conceal with the mural If you've got a plumb, one could make your individual by means of tying a heavy object at the end of a rope This line is very important since it is the guide to start placing your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of 50 cm(19") Panels are acquired published continually on a roll and numbered at the top Cut self reliant panels and do a preview on the floor following the numerical order from left to correct Measure with a meter the height of your wall If it&;s lower than the photomural, it is best to reduce it to fit properly Do it when you have it at the surface but go away a margin of an inch to right any differences in level on the wall STEP 3: Prepare the glue You may possibly buy the glue out of your supermarket, confirm it&;s for non-woven wallpaper use Prepare the glue following the directions at the bag of the glue to procure Do it slowly So you may obtain a uniform combination and with out bubbles STEP 4: Attach the paper to the wall Applying glue at the wall flippantly utilizing a brush or a paint roller Start distributing from the line you marked as a instruction manual to the plummet Don&;t paste the entire wall, do it solely in the subject that will disguise the 1st panel on the left, leaving a couple of inches outside the proper Apply the 1st panel of the mural at the wall beginning at the peak left Check that's aligned with the handbook Presses opposed to the paper with a dry curler or sponge to remove any air bubbles Place the following panels within the same manner in numerical order The panels must never be mounted on one another yet are set on edge Clean the surplus glue with a moist sponge STEP 5: Finishing With the help of a ruler and a cutter, adjust the perimeters and the end and backside of the wall if vital Let dry 24 hours; you will get an ideal end result

• 
• 
• 
• 
• 

Gözden geçirmek