Açıklamalar

• NEW ARRIVAL GEYA G2R Din Rail 2P 4P ATS Dual Power Automatic Transfer Switch Electrical Selector Switches Uninterrupted Power 25A forty 63A 110V/220V BEST ATS QUALITY IN Buydo---SILVER CONTACT POINT & RED COPPER PARTS & STABLE RELAY CONTROL City Power ⇆ Generator G2R ATS Usage Precautions: 1 220V ATS shouldn't be used with a voltage lower than 185V, in any other case the coil could burn out 2 110V ATS should not be used with a voltage less than 90V, in any other case the coil may burn out three The change can't be manually switched when in automatic mode, in any other case the coil could burn out three 4P ATS make sure right connection of part sequence,otherwise the contacts may perhaps burn out General GEYA G2R-63 automated transfer switch is a PC class rare change-over switch, with two-station design (commonly used for A and standby for B), appropriate for AC systems with AC 50-60hz and rated latest 6A-63A The main function of the automatic move swap is when the foremost power (common strength supply A) fails, the ATS will routinely swap to the backup strength (Backup power delivery B) to proceed working (switching speed <50 milliseconds), which may efficiently resolve the worries brought on by strength outages When both A and B have electricity, precedence is using A Power NOTE: 1 Manual/automatic operation can make sure the opening and closing functionality of electrical operation, but in handbook operation , there's no warrantly because of the diversified _opening/closing speeds of the operators In handbook operation, there's possible for excessive silver alloy loss Therefore, the selector swap must only be pulled to the manual role in spite of everything power has been bring to a halt for inspection and upkeep of the operating formulation and contact news 2, Normally, pull the selector swap to the electric function When manual operation is required, pull the selector switch to the manual function After guide operation is complete, pull the selector switch from the manual function to the automatic position The control circuit TSE is immediately energized After the substitute over is completed, the inner swap will injury the coil within the control circuit, and the coil can paintings usually at 85%-110% of the rated working voltage Too low input voltage can cause the coil to overheat and burn out Attention!When manual operation the mode alternative change must be in "manual" role Company Information

• 
• 
• 
• 
• 

Gözden geçirmek