Opisy

• DC5-12V Latching Relay Module with Touch Bistable Switch MCU Control One Channel Relay Power Supply Accessories Feature: 1 Low energy consumption, low strength ripple, sufficient materials, high efficiency and stability, safe and secure 2 Single-chip microcomputer control, steady and dependable performance, strong anti-interference capability 3 Onboard DC-CD voltage stabilization, huge enter range, low strength consumption four On-board contact swap test, which might straight test the stability, and may set off the switch externally It is provided with a terminal block and leads, making it more handy to use five Wide vary of uses, main uses: control of family appliances, management of various household lamps and various family appliances Factory package control, used for the control of varied small current control, excessive voltage and excessive power merchandise Product parameters: Power supply voltage: DC5-28V extensive voltage Supply current: more than 100MA Load: 250V 10A (AC) or 30V 10A (DC) Size: 50mm*26mm Aperture: 3MM Module interface: DC+: Connect to DC five to 28V nice pole DC-: connect to the unfavorable pole of DC NC: Normally closed finish COM: public terminal NO: Normally open (refer to wiring diagram) Instructions: Press the S2 button and the relay could be locked Press it again and the relay may be disconnected You can also connect an exterior inching switch and set off it with a low point Instructions for use: 1 According to the wiring diagram, connect the DC strength delivery first The strength delivery can't be related reversely Although there is a defense circuit, it can't be related reversely for a long time During installation, the board can be fixed on an edge object in step with the actual situation 2 Connect the wires and connect to the 5-28V power supply After the flexibility is grew to become on, the red LED gentle turns on, indicating that the power is supplied usually Press the verify button, the relay is attracted and locked (you hear "tick"), and the fairway LED light turns on on the similar time; press the relay back The disconnection is heard ("tick") and the green LED mild is going out on the similar time 3 The set off can be related to an external inching change This module is supplied with terminals and leads and may be directly related to the inching switch four You also can use other sensor modules for triggering As lengthy because it is a low-level trigger, it is valid and has extra space for expansion five The wiring should not be too thin to make sure that the twine can face up to the corresponding current 6 This module makes use of a relay to regulate the load and may withstand a lot under 250V 10A (AC) and 30V 10A (DC); the lifespan below 7A is 1 million 7 Power supply voltage: 5-28V large voltage eight Supply current: more than 100MA nine This module makes use of DC-DC voltage stabilization, and a slight fever is standard It is normal for the relay to generate heat even after working for a long time The load strength must leave a undeniable margin for the relay load, and keep away from high energy (2000W) and long-term operation Product List: 1X module 1X2P terminal

• 
• 
• 
• 
• 

Recenzja