Opisy

• STEP 1: Choose a Correct Type Device Current/Factor = Selection Current Selection Current * Factor = Device Current PS: The coefficient depends upon the kind of load you would like bring the equipment Resistive Load:40~50% Inductive Load12% STEP 2: Choose a Suitable Heat Sink During the useage of SSR, it's going to give out many of heat, so with a purpose to make bigger the lifetime of your SSR, please set up a heat sink , also if the current is over 60A,the cooling fan additionally required PS: Our Heat Sink include screws (for set up heat sink) NOTICE: 1 within the solid-state relay is a semiconductor A semiconductor switch is a non-physical contact change if use a multimeter diode or resistor to test ,it consistently reveal a high-impedance state, (multimeter light red) 2 to the standard detection tips of stable state relays: a load is required to check the switching state Using an incandescent lamp as a dummy load is an obvious approach to test continuity

• 
• 
• 
• 
• 

Recenzja