说明

• Product Description Working Voltage: DC4V-12V (DC4V 4 4 5V 6V 7 9V 12V) All is fine Quiescent /Standby Current: 7-9ma Working Current: 70-130ma ( if your strength supply is mini battery , you should care how long can it work for you) Relay Standard : 20A (( 14VDC 12A 120VAC 7A) Max Load: 10A (have higher load lower than 7A) Size : 34*23*15mm Working Frequency: 315MHZ/433 Optional Learning Code: Learning Button to add Transmitter Working Mode: Momentary Toggle Latched adjusted by way of Learning Button Momentary----- Press and Hold---ON, Release----OFF Toggle-------Press one time ----ON Press it again ----OFF Latched--------Press A ----ON, Press B-----OFF (Latched Mode will ship with 2 Button Transmitter) Momentary 5s Time Delay OFF----- Press and Hold---ON, Release----5s laterOFF V- -------------------Input GND – V+ -------------------Input VCC + NC---------------------Normally Close COM------------------Common NO---------------------Normally Open Momentary Toggle Latched adjusted by learning Button Latched ----------Press the training button until the receiver LED indicator flash for 1 time then release it Momentary------Press the learning button until the receiver LED indicator flash for 2 occasions then launch it Toggle-------------Press the learning button till the receiver LED indicator flash for 3 times then release it Momentary 5s Time Delay OFF-------Press the learning button until the receiver LED indicator flash for 4 instances then launch it Clearing Code Press the Receiver learning button and maintain ，until the Receiver LED indicator Flash for 1 instances ,and Flash rapid for two times, and Flash rapid for three times ,and Flash speedy for 4 occasions ,and Flash instant for five occasions ,then release it , it capacity the code were cleared Learning Code Momentary/Toggle Mode Press the Receiver studying button, when the Receiver LED indicator is ON then release it , then press the transmitter Button for 1 time , press the same transmitter buttin for Second times , then press the same transmitter button for the 1/3 time ，each time receiver LED indicator will flash for one instances , it means studying is finished Latched Mode Press the Receiver learning button, when the Receiver LED indicator is ON then launch it , then press the transmitter A button for 1 occasions ,Receiver LED indicator flash for 1 time,then Press transmitter B button for 1 occasions ,Receiver LED indicator flash for 1 occasions then press the transmitter B Button again , Receiver LED indicator flash for 1 times, it capability learning is finished

• 
• 
• 
• 
• 

审核