1
The dual power automatic change is a newly developed miniature household power switch, which is principally used to check whether the foremost energy delivery or standby power delivery is normal When the conventional strength delivery is abnormal, the standby power delivery begins to work immediately, which guarantees the continuity, reliability and security of power supply This product is specifically designed for household rail instailation and is specifically used for PZ30 distribution field
The dual energy automatic swap is suitable for emergency power delivery techniques with 50 or 60Hz and rated(L+N) 230VAC has the traits of stable constitution dependable conversion, handy installation and upkeep and lengthy carrier life It is broadly used in different occasions where strength failure can't be sustained, and can be operated through electricity or manually consists of TSE and controller
According to lEC60947-6-1,Part 6-1: multifunctional kit and switchgear is formulated it may be viewed that ATS is the most qualified low-voltage switchgear and control system
2 operation time and set up situations
2 Ambient air temperature
The maximum temperature shall not exceed 40℃, the minimal temperature shall not be less than -5℃, and the typical temperature within 24 hours shall not be increased than 35℃
2 Altitude
The altitude of the installation website shouldn't be larger than 2000m
2 Atmospheric circumstances
When the utmost temperature reaches 40℃, the relative humidity of the installation site shouldn't exceed 50%; when the temperature is the minimal temperature -5℃, the relative humidity is higher, for example, the temperature is 25℃, and the relative humidity is 90% Due to the temperature change, particular measures needs to be taken to deal with the occasional condensation at the floor of the product
2 Pollution grade
The pollutants grade of ATS conforms to grade 3 laid out in IEC60947-6-1
2 Installation class
The set up variety of ATS conforms to the class specified in1EC60947-6-1
2 Installation conditions
ATS can be installed vertically in control cabinet or distribution cabinet yes the installation distance meets the necessities in Figure 1