Description

• Parameter Working voltage: 6~40V DC (recommended 6-36V ) Rated current: 5A Module Power consumption: 0 (without load motor), static 0 Signal input: availbe in low-level , input Optocoupler is destructive pole if voltage under 2V meaning have signal Response speed: K1 K2 are 20mS , SW1 SW2 are 50mS Size: 83 * forty six * 20mm / 3 * 1 * zero inches Active life: > 1 million instances "Cycle" and "Single round trip" mode Wiring: Function Description: Forward and Reverse start buttons: K1 / K2 ; Limit Buttons: SW1 / SW2 Self-locking mode: 1- quick press K1, the motor begins operating ahead instantly and prevents after SW1 is closed 2- short press K2, the motor starts running reverse directly and forestalls after SW2 is closed Inching mode: 1- press and keep K1, the motor begins working ahead instantly and forestalls after SW1 is closed 2- press and keep K2, the motor begins running forward immediately and stops after SW2 is closed Package:1pcs TKS-M8 DC Motor Driver ModuleFrequency Q/A 1 what&;s the variation between "inching" mode and "self-locking" mode self-locking mode: quick press the ahead switch (k1) , the motor working ahead , even you release k1, the motor nonetheless working it's going to no longer give up till encounters a opposite sign (k2) or (sw2) incing mode: press and hold the forward swap (k1) , the motor operating forward, if release the k1, the motor will give up directly 2 what are the necessities for the signal ? Can i connect a sensor ? sign is vaild at low point , it can be connected to three-wire sensors (NPN-NO type), k1 , k2 , k3 are this form three Is the restrict signal valid in inching mode ? valid comparable to when k1 is on , motor will run forward , but the SW1 even have signal , it's going to give up at this time

• 
• 
• 

Review