Description

• DC6 380W BLDC Three Phase DC Brushless Motor Controller PWM Without Hall Sensor Hall Motor Control Driver Board Dropship Spain and Russian Warehouse Product This force is a DC three-phase brushless and Hallless management board, and the motor can paintings usually without Hall BLDC wide voltage 6 excessive energy 380W DC three-phase high-speed brushless sensorless controller, new PWM signal input help three formula PLC 0-5V analog sign enter management Special directions for external signal input: 1 The connection of the V/P quick contact suggests that the PWM signal enter efficiently acknowledges the real PMW signal to help the three system, and the PMW signal needs to be input from the 2 ports (PWM GND) of the terminal 2 When the V/P short touch is disconnected, the 0-5V analog sign enter is legitimate (the default is disconnected on the factory) When the analog number is input, the built-in potentiometer at the board can be utilized to adjust the speed If you want to connect an external 0 For -5V analog sign input, you need to unplug the jumper cap at the board to cut off the potentiometer divider signal, after which enter the 0-5V analog signal from the two ports (0-5 GND) of the terminal The most voltage should not exceed 5V 3 The forward and opposite rotation and the brake are grounded through a switch, which is low-level fantastic The external MCU also can give low-level signals The front row of wiring terminals are weak latest signals straight input to the MCU master control, and can't be touched or touched High voltage and strong current Interface Description: 1 V W 3-phase line output related to brushless motor 2 5V GND The motherboard comes with 5V (current does not exceed 200MA) three VCC GND main power supply (external DC power supply) 4 SC velocity pulse sign output (only the interface is reserved, no longer for technical support) five DIR ahead and opposite control maintain the low point effective (can be connected to the floor external switch) 6 BRAKE brake control retains low level active (can be linked to the ground with an exterior switch) 6 PWM speed control sign twin enter terminal (on-board potentiometer velocity control can also be switched by jumper to attach an external 0-5V analog quantity PWM responsibility cycle signal enter speed control) To Full-chip technology, steady performance, and user-friendly design, all interfaces use terminal blocks, typical warmth sink, on-board speed potentiometer, and might be used when the hand is powered on, saving time and worry Motherboard specifications: Product name: zs-x11f-2 Working voltage: 6 Drive current: rated 16A plus air-cooled heat dissipation 30A Maximum power: 380W Overcurrent protection: Yes Locked-rotor protection: Yes (after locked-rotor, the present will routinely drop and run at intervals) To Over-temperature protection: Yes (over-temperature strength is halved) To Maximum speed: 224000 RPM (2 pole motor), 74000 RPM (6 pole motor), 40000 RPM (12 pole motor), 35000 RPM (14 pole motor) Product size: size 63MM*width 45MM*height 31MM Weight: about 76g Precautions: 1 Reverse connection of the fine and unfavourable poles of the flexibility supply on the motherboard will cause permanent damage to a few of the chips at the board (even if it doesn't work for 1 second) 2 There is sampling over-current defense on the output of the motor throughout standard operation Because the power and current of the module are very large, please don't artificially short-circuit the module when the module is not working usually Once the short-circuit, the circuit may be burnt and the tube may possibly burst, the 1st wiring examine machine Please use small latest and coffee voltage test, after ok, then observe high latest and excessive voltage Because it is a bare board module, please eavesdrop on the insulation of the wiring head It is exactly forbidden that solid voltage touches the board parts To 3 Do now not connect to the motor that is obviously inconsistent with the power module voltage, current, or power

• 
• 
• 
• 
• 

Review