Description

• Product Features: This motive force is a DC three-phase brushless hallless control board The motor can paintings normally without hall BLDC wide voltage 6 high energy 380W DC three-phase high-speed brushless non-inductive controller New PWM signal input, help three components PLC 0-5V tactile, signal input management External sign input particular instructions: 1/P quick connection is the PWM signal input is valuable in identifying the genuine PMW sign to assist three system, you must enter the PMW sign from the 2 ports of the terminal (PWM GND) 2/P brief touch is disconnected is 0-5V mimic sign enter high-quality (factory default disconnected), in the analog input, you need to use the board comes with a potentiometer voltage divider speed control, if you wish to external 0-5V mimic signal enter must be unplugged from the board jumper cap to cut off the potentiometer divider signal, and then from the terminal two ports (0-5 GND) to enter the 0-5V mimic signal, the voltage is maximum Do no longer exceed 5V 3 Forward and opposite and brake by way of a change floor is low-level effective, can be external MCU to the low-level signal, the entrance row of terminals, are susceptible electrical signals immediately into the MCU grasp control, can't touch and phone with high voltage and powerful latest Interface description: 1 U V W 3-phase line output related to the brushless motor 2 5V GND Main board comes with 5V (current doesn't exceed 200MA) 3 VCC GND mains energy delivery (external DC energy supply) four SC pace pulse sign output (only interface, no technical support) 5 DIR Forward and Reverse Control (can be switched to ground) 6 Brake Control (can be switched to ground) 6 PWM speed management sign twin inputs (the board comes with potentiometer speed control is also switched in the course of the jumper external 0-5V contact the proposed amount of PWM duty cycle signal input speed control) All chip technology, secure performance, humanized design, interface with all terminals typical warmth sink on-board speed potentiometer to the palms of the flexibility can be utilized to save lots of time and worry! Main board specifications parameters: Product name: zs-x11f-2 Working voltage: 6 Driving current: rated 16A plus air-cooled cooling 30A Maximum power: 380W Over-current protection: Yes Blocking protection: Yes (after blockading the present routinely drops to hit the isolation operation) Over-temperature protection: Yes (over-temperature energy halved) Maximum speed: 224000 RPM (2-pole motor), 74000 RPM (6-pole motor), 40000 RPM (12-pole motor), 35000RPM (14-pole motor) Product size: L63MM*W45MM*H31MM Weight: 76g Attention: 1 Power delivery on the motherboard strength delivery nice and unfavourable polarity reversal will trigger permanent damage to some of the chips on the board (even if 1 second can not) 2 In ordinary operation, the motor output has a sampling overcurrent protection, due to the module power recent are very broad Please don't short-circuit the module isn't always working properly, however the short-circuit has the potential of burning line burst tube, the first wiring check please use a small recent and low voltage test, to be ok, after which throughout the high recent and high voltage, due to naked board module for sale, pay attention to the insulation of wiring wires and forbidden to touch the board elements of the solid voltage 3 Do now not connect with the force module voltage, current, power section would not tournament or far from the motor Product list: 1X driver board

• 
• 
• 
• 
• 

Review