说明

• NEW ARRIVAL GEYA G2R Din Rail 2P 4P ATS Dual Power Automatic Transfer Switch Electrical Selector Switches Uninterrupted Power 25A forty 63A 110V/220V BEST ATS QUALITY IN Buydo---SILVER CONTACT POINT & RED COPPER PARTS & STABLE RELAY CONTROL City Power ⇆ Generator G2R ATS Usage Precautions: 1 220V ATS shouldn't be used with a voltage lower than 185V, in any other case the coil may possibly burn out 2 110V ATS should not be used with a voltage less than 90V, otherwise the coil may perhaps burn out 3 The change can't be manually switched when in computerized mode, in any other case the coil may possibly burn out three 4P ATS make certain right connection of section sequence,otherwise the contacts might burn out General GEYA G2R-63 automated transfer change is a PC category infrequent change-over switch, with two-station design (commonly used for A and standby for B), appropriate for AC programs with AC 50-60hz and rated current 6A-63A The leading operate of the automatic move swap is when the major power (common power supply A) fails, the ATS will mechanically switch to the backup energy (Backup power delivery B) to proceed working (switching pace <50 milliseconds), which may effectively resolve the concerns caused by power outages When either A and B have electricity, priority is utilizing A Power NOTE: 1 Manual/automatic operation can make sure the opening and shutting functionality of electric operation, but in manual operation , there isn't any guarantee due to varied _opening/closing speeds of the operators In manual operation, there may be possible for immoderate silver alloy loss Therefore, the selector change should solely be pulled to the manual position after all energy has been cut off for inspection and maintenance of the operating system and speak to news 2, Normally, pull the selector change to the electrical position When handbook operation is required, pull the selector swap to the manual role After guide operation is complete, pull the selector switch from the guide position to the automatic function The control circuit TSE is instantly energized After the exchange over is completed, the internal swap will injury the coil within the control circuit, and the coil can work normally at 85%-110% of the rated operating voltage Too low enter voltage may cause the coil to overheat and burn out Attention!When manual operation the mode selection swap must be in "manual" role Company Information

• 
• 
• 
• 
• 

审核