说明

• Ultra Flexible Removable Magnetic Build Surface Plate for Creality Ender 3 Ender three Pro CR-20 3-D Printer Heated Bed Parts Feature: 1 It is more immune to excessive temperature, refuses to warp edges, can be utilized repeatedly, smooth to clean, smooth to install, handy and fast, and able to use 2 Black frosted surface with coarse sand sample design The surface with coarse sand sample is black frosted surface, which has solid flexibility and high temperature resistance, smooth to adhere to the broadcast product, and straightforward to take out and separate 3 PC material fastened comfortable magnet material, flame-retardant, wear-resistant, anti-oxidation, low molding shrinkage rate, long-term resistance to 70℃ high temperature with out demagnetization, the recent melt materials and the printing layer are properly mixed to lessen the deformation attributable to shrinkage, and avoid warping, wear-resistant and scratch-resistant , Resistant to dirt and hand sweat, can be utilized repeatedly four Easy-to-remove 3-d printing platform compatible for PLA and PLA-based supplies To use it, simply glue the lowest plate to your construct plate and begin printing, peel off the tip plate with the finished print, and then peel the top plate from the print Snap the top plate back to its common position for a higher around of printing Specification: Applicable model: for Creality Ender-3/Ender-3 Pro/CR-20 and different FDM 3D printer heated mattress Colour: Black Material: PC materials fastened delicate magnet material Product size: 235*235*1mm Net weight: 496g Instruction: The product is divided into two parts: A (upper)+B(lower) -Part A: The height is a matte surface, and the again is magnetic (the interaction with the entrance of Part B plays an attractive role) -Part B: The height is magnetic (with the adsorption below the A part), the back is the adhesive (posted on the printer platform, which performs a set role) How to use: To use it, simply stick the bottom sheet onto your construct plate place, then place the end half of on peak of the magnetic decrease and begin printing, peel up the tip sheet with executed prints, then flex the top sheet to make the mannequin pop off from the construct floor Snap the top plate back into place, and you are prepared for a higher round of printing If it fails to adsorb, please rotate it 90 degrees and try back Note: This product is rated for use with PLA filaments ONLY This product isn't always for use with high-temperature printing applications above 70 °C There could also be slight size deviations due to guide measurement, diversified measuring methods and tools The photograph might not reflect the particular colour of the thing because of varied photographing light, attitude and demonstrate monitor 1 X Build Plate Upper Part 1 X Build Plate Lower Part

• 
• 
• 
• 
• 

审核