说明

• 50ml Kafuter UV Glue UV Curing Adhesive K-300 Transparent Crystal and Glass Adhesive with UV Flashlight Product Features: K-300 is a modified UV or visible gentle curing acrylic adhesive, low odor, high transparency, high bonding strength,low viscosity, clean deaeration , customarily used in large- subject glass crystal bonding, similar to : glass mosaic,glass crafts, crystal crafts Key functionality indicators: Appearance: colorless or mild yellow transparent liquid Viscosity cps: <110 (Brookfield DV-II viscometer , 25 ° C, SC 4-15 rotor 150rpm) Hardness ( Shore D): 75 (GB / T 531-1999 curing examine ) Typical curing nature: K-300 might be cured below ultraviolet mild , the sun will slowly solidified 220-260nm gentle source supports surface cure Cure rate , depth, and ultimately curing effect is dry and UV light supply , exposure time , gentle transmittance connected materials Suggested by experiments to ascertain the ultimate curing job Positioning time: 10 seconds -125w high-pressure fluorescent , four mW / cm ⊃2; UVA Full remedy time: 180 seconds -125w high-pressure fluorescent , four mW / cm ⊃2; UVA Typical cured properties: Tensile shear strength (GB 7124-86) overlapped area of 25 × 12 = 312: glass / stainless-steel , ≥ 10MPa Use these steps: 1 Depending on the materials floor medication , surface dry and clear , no weak boundary layer ; 2 interface adhesive bonding materials at the need for continuous coating, be careful not to disperse ; three light positioning the glue into the quick ultraviolet curing lamp radiation, until the hand nudging fixed; four to remove the excess glue with a knife to scrape the glue overflow , or a comfortable material , paper towel and gently erase the excess glue can also be dipped in acetone, alcohol wipe ; 5 full cure time high radiation , till solely cured , word the temperature isn't too high ; 6 dipped in acetone, alcohol, cleaning materials with a smooth material or paper towel and gently wipe the bonding good materials Instructions for use: 1 , the adhesive floor clean, dry and freed from grease , you may wipe with acetone , hair dryer 2, the UV lamp positioned curing , the curing rate relies on the glue to soak up mild energy from the sunshine source related to , the sunshine transmittance material and different factors 3 , the operation shouldn't squeeze too tough to be sticky , and shall now not be over and over moved apart adherend 4, utilizing the remainder of the glue not fall again to the original packaging to circumvent contamination Note: Avoid contact with eyes, skin and clothes This pair of eyes and a slight skin inflammation If by chance splashed into the eyes , rinse directly with lots of water , as there does not should visit health center Rinse directly with cleaning soap and water after pores and skin contact Please wash earlier than they'll wear the clothing Do no longer allow touch with adolescents Storage: This product is touchy to gentle and heat , you need storage in a cool, dry place, away from mild below 28 ° C, valid for 365 days Note :flashlight(not include battery)

• 
• 
• 
• 
• 

审核