说明

• 1 This mannequin is an incorporated mold, which can't be disassembled Please observe 2 The diameter of the hole on the higher part of the mildew is barely larger, which is designed to facilitate demoulding 3 After the wax liquid is fully cooled, you would knock the mold gently to demould the finished product, or you should buy our small wooden hammer demoulding software to knock the mold gently to demould smoothly four As the method shows, the mold may have a lower or small defect at the joint, I hope to get your kind realizing

• 
• 
• 
• 
• 

审核