Beschreibung

• Diesel Generator Water Heaters 120V 240V Self-circulating Engine Preheater heating generator Thermostat water heater pre heating generator diesel jacket diesel heater parts 1 must be intailed vertically and make heater outlet upwards 2 needs to be mounted under generator base with bolts Pipe Installation Instructions 1 out cooling liquid obviously 2 pipe and becoming in the vacuum facet of cooling method wisely and possibly in I owe rest position Then hyperlink heater inlet with steel tube of generator by utilizing a 8mm hose and tighten up lathedog 3 heater outlet to pressure facet of water pump through greater than 160mm outlet pipe Hose link heater outlet with pipe becoming of generator four , t link heater outlet pipe to generator until we pour cooling liquid into outlet pipe entirely It goals to release air within the outlet pipe and stop any freezing of cooling liquid and operation failure After linking outlet pipe to generator, maintain pouring water Warning: 1 Outlet pipe hose should be as immediately as possible, and not be flat 2 Hoses shouldn't be torisoned or ringed during installation three Hose outlet pipe should not be larger than junction of generator Checking After Installation 1 heater and pipes fitting whether they are installed wisely and firmly 2 generator Check cooling liquid pipe, upload water to correct water level and then test wether there's leakness or not And stop and funky generator 3 heater outlet to pressure facet of water pump through greater than 160mm outlet pipe Hose hyperlink heater outlet with pipe fitting of generator 4 can feel warm temperature of outlet pipe or hose connecting to generator Otherwise,switch off heater battery Then release air and hold heater working 5 a couple of mimutes, check whether or not generator and inlet hose grow to be heat •stably and inspect heater automated working condition-open-close-open Warning: 1 Don&;t turn on till heater is poured into water or cooling liquid fully, it ends in heater injury 2 Don&;t function until earth wire is put in Warning (CAUTION): 1 The preheater can't be installed instantly on the friction: 2 The water outlet pipe needs to be linked to the better water point of the engine and cannot be bent downward, in any other case the recent water can not movement upward 3 When reinstalling the coolant, don't join the Yirui pipe that leads into the water, and fix it until you see the water, which might get rid of the air bag: 4 Antifreeze and cooling water must be entirely diluted before putting into the engine five After the preheater is installed, it is suggested to start the engine for 10 minutes earlier than powering on: 6 Pay consideration to the substitute of the surface temperature of the preheater after energy on If the temperature of the shell rises and the opening pipe isn't always hot, give up the power for inspection

• 
• 
• 
• 
• 

Rückmeldung