Beschreibung

• Food Waste Disposal â– Snap design is simple to install, splash-proof and silent â– No blade grinding + deep double layer shredding, safe and extra efficient â– Pure copper motor with German imported technology, stronger energy â– Overload defense + high temperature protection, longer lifestyles One Click - So Easy Operation steps 1 Turn on the water tap 2 Start the processor with one button 3 Pour the food waste into the grinding chamber 4*Please note: After looking ahead to the meals to be completely ground, proceed to keep the tap on and hold it on for 5 seconds after which flip it off five The machine is set with overload defense device, exceeding a undeniable load or overheating, the mechanical device will routinely shut down WHY ROUNY â– Solid and excellent good high quality â– 3-layer chrome steel grinding formula â– Simple and simple to operate Suitable Size â– The product is suitable for 90~110mm sink opening â– The product comes with air change as standard, and the commended installation gap is 28~30mm â– It is suggested that the lowest thickness of the installable sink be inside 10mm Product Q & A Q: How can I set up the machine if the sink diameter isn't 11cm? A: The machine is acceptable for sink diameter of 11cm, if the sink diameter isn't suitable, we advise you need to use reducer (reducer ring) to alter the sink diameter Q: How massive is the opening of the air switch? A: It is usually recommended that the diameter of the opening within the counter top or wall is 2~3cm Q: Is the mechanical device clean to install? A: It is very easy to install, installation calls for some pressure We simulate the set up steps in the product video, presently greater than 99% of buyers can understand the installation steps through the video and instructions, when you discover it very difficult, it is suggested to ask a professional for installation Q: Is the stone sink compatible for installing the machine? A: It is suggested to guage through the thickness of the sink bottom, if the bottom thickness is 10mm (1cm) or less, it is probable to put in the machine It is suggested to shine the stone sink mouth tender before installing the mechanical device Q: How can I examine if the machine is working properly after I obtain it? A: Please install the air switch of the machine, then plug within the power and press the button, the mechanical device can start or shut down usually Q: I acquired a new mechanical device and found that there are scratches inside the grinding disc, how can I do? A: The product is inspected on the factory, powered on and the machine is began Therefore, the grinding disc left operating traces, it is a usual situation, buyers can set up and use the mechanical device normally, please do not worry Q: What should I do if the machine is stuck? A: A jammed state suggests that the machine has activated the electrical protection operate Please cut off the power and clear all of the residues and foreign items in the grinding chamber (especially the sting gap), insert and turn the grinding disc with a screwdriver, and eventually press the red reset change lightly and tool on to activate usually

• 
• 
• 
• 
• 

Rückmeldung