Beschreibung

• Ultra Flexible Removable Magnetic Build Surface Plate for Creality Ender three Ender 3 Pro CR-20 three-D Printer Heated Bed Parts Feature: 1 It is extra proof against excessive temperature, refuses to warp edges, can be utilized repeatedly, easy to clean, clean to install, convenient and fast, and able to use 2 Black frosted floor with coarse sand pattern design The surface with coarse sand sample is black frosted surface, which has solid flexibility and extreme temperature resistance, clean to adhere to the broadcast product, and straightforward to take out and separate 3 PC material fixed delicate magnet material, flame-retardant, wear-resistant, anti-oxidation, low molding shrinkage rate, long-term resistance to 70℃ hot temperature with out demagnetization, the recent soften materials and the printing layer are effectively combined to lessen the deformation brought on by shrinkage, and avoid warping, wear-resistant and scratch-resistant , Resistant to grime and hand sweat, can be utilized over and over 4 Easy-to-remove 3-d printing platform suitable for PLA and PLA-based supplies To use it, easily glue the lowest plate in your build plate and begin printing, peel off the tip plate with the completed print, after which peel the top plate from the print Snap the end plate again to its long-established position for a higher around of printing Specification: Applicable model: for Creality Ender-3/Ender-3 Pro/CR-20 and other FDM 3D printer heated bed Colour: Black Material: PC material fastened comfortable magnet materials Product size: 235*235*1mm Net weight: 496g Instruction: The product is divided into two parts: A (upper)+B(lower) -Part A: The height is a matte surface, and the again is magnetic (the interaction with the entrance of Part B performs a sexy role) -Part B: The height is magnetic (with the adsorption below the A part), the back is the adhesive (posted at the printer platform, which plays a set role) How to use: To use it, easily stick the lowest sheet onto your build plate place, then position the top half on height of the magnetic decrease and start printing, peel up the tip sheet with completed prints, then flex the end sheet to make the model pop off from the construct floor Snap the end plate again into place, and you are prepared for a higher round of printing If it fails to adsorb, please rotate it 90 levels and take a look at back Note: This product is rated for use with PLA filaments ONLY This product isn't to be used with high-temperature printing functions above 70 °C There may be slight length deviations due to guide measurement, diversified measuring methods and tools The picture might not replicate the actual coloration of the article because of different photographing light, perspective and reveal computer screen 1 X Build Plate Upper Part 1 X Build Plate Lower Part

• 
• 
• 
• 
• 

Rückmeldung