Beschreibung

• How to use our wallpaper? STEP 1: Prepare the wall floor Your wall needs to be permanently flat, clear and dry Levels rough surfaces, rough, holes and choppy spots Your wall must be a uniform coloration If not, you would possibly observe differences in colour in your wall once put in If your wall has a number of colors, we endorse that you paint again Make a vertical line with a plumb line on the left fringe of the area you prefer to disguise with the mural If you have a plumb, one can make your own through tying a heavy object at the finish of a rope This line is very important since it is the guide to start placing your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of forty eight cm(19") Panels are acquired published continually on a roll and numbered at the top Cut self reliant panels and do a preview at the floor following the numerical order from left to appropriate Measure with a meter the peak of your wall If it&;s lower than the photomural, it is best to lower it to fit wisely Do it once you have it at the floor yet depart a margin of an inch to appropriate any variations in point on the wall STEP 3: Prepare the glue You could buy the glue from your supermarket, confirm it&;s for non-woven wallpaper use Prepare the glue following the instructions at the bag of the glue you obtain Do it slowly So you'll obtain a uniform combination and without bubbles STEP 4: Attach the paper to the wall Applying glue on the wall frivolously using a broom or a paint curler Start distributing from the road you marked as a handbook to the plummet Don&;t paste the entire wall, do it solely in the field that will disguise the first panel at the left, leaving about a inches outside the right Apply the first panel of the mural on the wall starting at the height left Check that is aligned with the instruction manual Presses against the paper with a dry curler or sponge to take away any air bubbles Place the following panels in the identical manner in numerical order The panels must not be fastened on one another yet are set on edge Clean the excess glue with a moist sponge STEP 5: Finishing With assistance from a ruler and a cutter, alter the sides and the top and backside of the wall if necessary Let dry 24 hours; you will get a perfect final result

• 
• 
• 
• 
• 

Rückmeldung