Beschreibung

• SX460 AVR Pressure Regulator WIRING (Refer to wiring diagram)1 ConnectF1, F2 to DC output port Connect the sensing port at 7, eight (the factory setupis 220V, if 110V is required, please connect 3, 4)3 External voltage regulator is as Figure 4 Connect a jumper from COM to the 50Hz terminal for 50Hz operation :please install 5A 250V fuse at energy input portas Figure 4WARNING:This Automatic Voltage Regulator isn't always geared up with loss-SensingProtection operate /Over Excitation Protection An further Over-Voltage Protection machine for load may be required to avoid probable damage to the kit or extreme personalinjury or death:243g t 2%Dimensions:135mmL*100mmW*49mmHSoft Start Ramp Time:2 sec( UFRO ): Slope 170% down to 30 HzUnder Frequency Protection:Set level ,95% HzUnit Power Dissipationt:Max wattExternal Volts Adjustment:7% with 1K ohm 1 watt trimmerThermal Drift:0% in step with C replace in AVR ambientVoltage Build-up:Residual voltage at AVR terminal> five VAC <+ 1% ( with 4% engine governing )Voltage Regulation Resistance:Min ohm Current:Continuous 4A ,Intermittent 10A for 10 sec Voltage:Max ninety VDC @ 207 VACOutput Frequency:50160 Hz, selectable Voltage:95~132VACor190~264VAC1 phase, jumper selectableNSensing Input1 INTRODUCTIO

• 
• 
• 
• 
• 

Rückmeldung