Beschreibung

• TANKE Hydraulic Disc Brake Calipers Front & Rear Black Brake For MTB Bicycle Brake Brand: TANKE Ownership: Taiwan, China Model: TB-RS919 Color: black/Red/Purple Installation gap spacing：R:34mm, F:70mm Category: hydraulic line pull disc brake Braking method: hydraulic piston two-way braking Description: TB-RS919 makes use of a new hydraulic line pull clamp technology, what is: hydraulic line pull? The block of the TB-RS919 is supplied with built-in brake oil, and then the brake clamp is used to control the brake of the hydraulic clamp The cylinder of the clamp is integrated brake oil Weight: TB-RS919 462g(front+rear) Before assembling the hydraulic disc brake on the assembly line, please carefully read the ensuing operations to prevent assembly errors attributable to incorrect meeting （1） Remove the brake pad plug （2） Fix the disc brake to the frame, guaranteeing to keep the disc brake in an unlocked state at the body at this time （3） the brake twine during the screw hole of the traction arm brake wire, pull the brake cord to make it in a tight state, and directly use a No four hex wrench to tighten the brake wire solving screw, with a locking torque of 6-8N m （4） counterclockwise to loosen the fixing screw of the traction arm until the traction arm is no longer fixed This step is significant and cannot be ignored （5） the brake lever and instantly use a No 4 hex wrench to lock and fasten the disc brake onto the frame, with a locking torque of 6-8N m: （6） the brake lever, rotate the tire, and test if the disc rubs opposed to the brake pads If there's any collision, loosen the solving screws of the disc brake to examine if it's caused by the cable pulling and tilting the disc brake Then repeat step 5: （7） finishing up the above steps, try driving to check the brake feel and verify whether or not the car is braking If the brake feel is low and the brake lever is near to the horizontal pipe, it's necessary to add oil into the oil disc The oil replenishment job is the same as that of an everyday oil disc （8） the disc brake can't operate properly, please consult a professional or high quality technical workforce from the producer till the difficulty is resolved earlier than cyclingRoad motorcycle line pull oil dish Open circuit design, oil storage tank oil sufficient to make up for brake pad wear, Increase the carrier life of brake pads1 There is an oil storage tank above the higher pump which is an open circuit design, and there's no oil garage tank which is a closed circuit design 2 oil within the open design oil storage tank would be added to the decrease pump, and the gap could be robotically adjusted after the brake pad is worn to increase the carrier lifetime of the brake pad; The closed-circuit design has no oil garage tank, and after the brake pads put on out, the space continues to develop until the car finally fails to brake Brake pads have a totally brief carrier existence three Now at the market, there are TRP and RUSH BH-RS919, and remainder are closed circuit designOil garage tank design There&;s sufficient oil in the tank to cover the brake pads The amount of wear and tear will increase the provider life of the brake pads

• 
• 
• 
• 
• 

Rückmeldung