Description

• How to apply our wallpaper? STEP 1: Prepare the wall floor Your wall needs to be permanently flat, clear and dry Levels rough surfaces, rough, holes and choppy spots Your wall must be a uniform coloration If not, you may be aware variations in colour in your wall once put in If your wall has a number of colors, we promote that you simply paint back Make a vertical line with a plumb line on the left fringe of the area you prefer to cover with the mural If you have a plumb, one can make your individual via tying a heavy object at the end of a rope This line is significant because it is the handbook to begin placing your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of 48 cm(19") Panels are received published continuously on a roll and numbered at the top Cut self sustaining panels and do a preview at the ground following the numerical order from left to correct Measure with a meter the height of your wall If it&;s lower than the photomural, you should reduce it to slot properly Do it once you have it at the floor but leave a margin of an inch to right any differences in point on the wall STEP 3: Prepare the glue You may perhaps purchase the glue from your supermarket, verify it&;s for non-woven wallpaper use Prepare the glue following the instructions at the bag of the glue you obtain Do it slowly So you will obtain a uniform combination and with out bubbles STEP 4: Attach the paper to the wall Applying glue at the wall evenly using a broom or a paint roller Start distributing from the line you marked as a instruction manual to the plummet Don&;t paste the whole wall, do it only within the area that may cover the 1st panel on the left, leaving a couple of inches outdoors the right Apply the 1st panel of the mural on the wall starting at the height left Check that is aligned with the guide Presses opposed to the paper with a dry curler or sponge to take away any air bubbles Place the following panels in the similar method in numerical order The panels must not be fastened on one another but are set on edge Clean the excess glue with a moist sponge STEP 5: Finishing With the help of a ruler and a cutter, adjust the edges and the tip and backside of the wall if mandatory Let dry 24 hours; you will get a perfect

• 
• 
• 
• 
• 

Review