Description

• 1. Remove the rubber cap and turn the enter shaft in order that the bolt head fits the opening of the rubber cap.And please confirm that the holding bolt has been loosened.2. Insert the motor shaft smoothly into the input shaft (make sure to insert it with out blocking)Be cautious not to tilt the motor in.3. Fix the motor on the reducer and tighten the bolts.4. Tighten the fixing bolts of the input shaft.5. Put a rubber cap on.Installation completed.In addition: the foremost of the replacement keyway motor is removed and can be installed as above.There isn't any should fear about sliding fees indicating the Hoove. VRSE specification for keyless motor installation1. Wipe away the rust inhibitor and oil on the motor shaft.2. Remove the rubber cover, rotate the drive shaft, and the pinnacle of the bolt is consistent with the rubber disguise hole.Make yes it's free (see figure 1 at the right).3. Insert the motor gently into the force shaft (insert smoothly with none obstacles).Be careful not to tilt the motor in (see figure 2 on the right).4. Install the motor at the reducer and tighten the bolts with the desired torque (see Table 1-Figure three on the right).5. Tightening the location bolt of the force shaft with the specified torque with a torque wrench (refer to Table 2 at the left and Figure 4 at the right),6. Press the rubber cover.That's it (see determine 5 at the right).

• 
• 
• 
• 
• 

Review