说明

• Product Introduction The ultralight F4 1S 5A AIO Brushless Flight Controller is back in inventory with new and upgraded aspects Compared to the previous version, the new board makes use of Serial ExpressLRS 2 instead of SPI ELRS 2 in order that it's going to support ExpressLRS V3 and in addition has a Frsky RX version to choose from We updated the FC with advantageous BMI270 gyro and BB51 ESC hardware In addition, this new board supports the Betaflight Blackbox function Bullet Point Come with a Serial ExpressLRS 2 receiver, which might be updated through Wi-Fi or Betaflight serial passthrough It is handy for pilots to flash any version of ELRS RX firmware and especially can flash ExpressLRS V3 without updating flight controller firmware The SPI Frsky version board reserves an SBUS port and a UART port, which is accessible for the SBUS protocol receiver or other exterior receivers Built-in an 8MB flash reminiscence chip dedicated to Blackbox logging It&;s a particularly powerful software for tuning and troubleshooting an FPV drone Integrated motor pin connectors, it is simple to install motors without soldering paintings Particular design with solely three ultralight weight, life like layout, and simple to construct With a 26*26mm mounting gap size, it is fully like minded with the whoop frame within the current marketplace Specification of FC CPU: STM32F411CEU6 (100MHZ) Six-Axis: BMI270 Built-in Receiver: Serial ExpressLRS 2/SPI CC2500 (Frsky) Receiver antenna: Line antenna FC Size: 30*30mm Mounting Hole Size: 26*26mm Firmware version: betaflight_4 (ELRS)/betaflight_4 (Frsky) OSD: Built-in BetaFlight OSD Blackbox: 8MB Recommend VTX: >=200mW, like BETAFPV M03 350mW VTX or TBS Unify VTX Power Cable: 55mm, with BT2 connector Weight: 3(ELRS)/3(Frsky), with out energy cable and BT2 connector Specification of ESC Power supply: 1S Current: 5A continual and height 6A (3 seconds) ESC firmware: A_X_5_ for Bluejay BB51 hardware Signal Support: D-shot150, D-shot300, D-shot600, Oneshot125, Multishot, PWM Betaflight Firmware and CLI F4 1S 5A AIO Brushless Flight Controller comes with the default firmware betaflight_4 (ELRS) or betaflight_4 (Frsky) The default firmware for Serial ExpressLRS 2 RX version supports ELRS V2 RX Pay attention, For the Serial ExpressLRS 2 version, ONLY the Betaflight firmware four and up begin to support this BMI270 gyro For the SPI Frsky version, DO NOT flash the opposite firmware, otherwise, the RX will be misplaced on top of things at a totally shut fluctuate We have already built our own firmware betaflight_4 for SPI Frsky RX version to assist BMI270 gyro Recommend Parts Battery: BT2 300mAh 1S Battery Frame: Meteor65 body / Meteor75 frame Props: 31mm 4-Blades props (for 65mm frame) / 40mm 4-blades props (for 75mm frame) Motors: 0603 motors / 0703 motors / 0802 motors VTX: M03 25-350mW VTX Package 1 * F4 1S 5A AIO Brushless Flight Controller (ELRS or Frsky) four * M1 Screws four * M1 Screws 4 * Anti-vibration Rubber Dampers

• 
• 
• 
• 
• 

审核