Descriptions

• How to apply our wallpaper? STEP 1: Prepare the wall surface Your wall should be permanently flat, clean and dry Levels rough surfaces, rough, holes and choppy spots Your wall ought to be a uniform color If not, you might observe differences in color on your wall once installed If your wall has a number of colors, we recommend that you paint back Make a vertical line with a plumb line on the left fringe of the area you prefer to disguise with the mural If you've a plumb, one could make your individual by means of tying a heavy object on the finish of a rope This line is significant because it is the handbook to start putting your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of 48 cm(19") Panels are acquired printed continually on a roll and numbered at the height Cut self sufficient panels and do a preview at the floor following the numerical order from left to right Measure with a meter the peak of your wall If it&;s less than the photomural, it is best to lower it to fit wisely Do it once you have it at the floor yet go away a margin of an inch to appropriate any variations in point at the wall STEP 3: Prepare the glue You may possibly buy the glue out of your supermarket, confirm it&;s for non-woven wallpaper use Prepare the glue following the instructions at the bag of the glue to procure Do it slowly So you'll achieve a uniform combination and with out bubbles STEP 4: Attach the paper to the wall Applying glue at the wall lightly utilizing a broom or a paint roller Start distributing from the line you marked as a handbook to the plummet Don&;t paste the whole wall, do it only within the subject which will cover the first panel at the left, leaving a couple of inches exterior the right Apply the 1st panel of the mural at the wall starting at the height left Check that's aligned with the guide Presses opposed to the paper with a dry roller or sponge to take away any air bubbles Place the following panels in the same way in numerical order The panels must not be fastened on one another but are set on edge Clean the excess glue with a moist sponge STEP 5: Finishing With the aid of a ruler and a cutter, alter the perimeters and the top and bottom of the wall if essential Let dry 24 hours; you'll get an ideal outcome

• 
• 
• 
• 
• 

Révision