Descriptions

• Features ■ Compact Design ■ Overload / Phase Loss / Locked Rotor protection ■ Accurately reveal the working recent (the best possible recent of L1 and L3) throughout the entrance panel LED exhibit ■ When time out occurs, the cause is displayed on the LED window ■ Phase loss defense (3 seconds) ■ Convenient application: Selective use of single-phase (1P) and three-phase (3P) via DIP change ■ Optional contact output [fail-safe (N)/non-fail-safe (R)]: simplify the adjustment of the contact state ■ Easy installation because of either Din Rail and Panel Mounting Used for - Low Voltage Induced Electromotor (600V Level) Protective Relay - Break-Down Watch Current Relay - Alternative Replacement for the Existing Relay Protetcion Protective Item Operating (Trip) Time Over-Current = O-TIME Phase Loss = three sec Locked Rotor = After D-time（Operating current> 200% of set current） Set After the installation is complete the settings as follows Set knob: D-TIME(Delay Time) Set two to 3 seconds longer than the motor beginning time Set knob: O-TIME(Over-current run time) Set less than the motor&;s patience time with over-current Set knob: Load(Rated Current) Set over 110% of the motor&;s rated recent of below 120% of its operating recent Trip Cause Indication Configuration Menu Specifications Current Range : Type05) 0 Type30) 3-30A Type60) 5-60A TYpe120) 10-120A Type600) Use an exterior CT(secondary 5A)over 120A with 05 type Operating Voltage(Un): Type220) 180-260VAC Operating Frequency: 50/60Hz Operating Power: <2W Operating Temperature: -20℃·····+55℃ Waiting(t): D-Time 1-30s O-Time 1-10s Asymmetry Set: %±5 Contact: 5A 250VAC Resistive Load Connection Diagrams: 35mm Din Rail(D) or Pane(P) Dimensions Construction Connection Diagram

• 
• 
• 
• 
• 

Révision