Opisy

• YIDI 5pcs Pneumatic Brass with Plated Push-in Air Tube Fittings Fitting Connection Connector Tee T PE 4 6 8 10 12 4MM 6MM 8MM 10MM 12MM Set Specification: Item No.: C-PE Connection Way: One-Touch Quick Push in Connection Type: Hose to Hose Design: Tee Material: Nitrile Rubber and Metal Copper Fluid Type: Clean Air, Vacuum, No Toxic Gas Applicable Hose: SolfNylon, Polyurethane Normal Operating Pressure: 0~10kgf/cm² (0~1.0MPa / 0~1.0bar) Max.Operating Pressure: 15.0 bar(1.5MPa) Negative Pressure: -750mmhg (10Torr) Ambient And Fluid Temperature: -20~120℃ (-4℉~248℉) Installation Instructions:InstallationGrasp the tubing and slowly push it into the suitable until it involves stop. The tubing may be locked by the spring gasket.RemovePush the release button to open the spring gasket so that the tubing can be released.Cautions: 1. Cleaning: Clean the piping before connection to remove debris. 2. Tubing Cut: Ensure a perpendicular lower with out scratches at the tubing's outer diameter. 3. Pipe Length: Avoid excessive bending; choose a proper pipe length. 4. Connection: After connecting, pull the tubing gently to ascertain its seal. 5. Release: Push evenly at the launch button flange for correct tubing withdrawal. 6. Removal: Avoid rotating the tubing fully throughout removal. 7. Assembly: Ensure no debris enters when screwing pipes and fittings together.Safety Instructions: 1. Pressure: Ensure zero stress within the tubing before removal. 2. Spatter Zones: Avoid common fittings in spatter-producing areas. 3. Monitor Conditions: Stay within specified pressure and temperature ranges. 4. Environment: Avoid corrosive gases, chemicals, and extreme conditions. 5. Placement: Avoid locations with heavy vibrations or shocks. 6. Direction: Install tubing within the correct one-way direction. Dimension:

• 
• 
• 
• 
• 

Recenzja