Opisy

• be careful: After removing the battery and the main board with water, clear the shell motion and blow the water to the bottom 1 Install a new water resistant ring and check the magnetic suspension clearance of the vibration motor There are two screws at the entrance and again that may be adjusted (about 0) when they are too close It is simple to find friction, inflicting irregular noise or vulnerable vibration Too distant will even cause vulnerable vibration 2 Install the most important board and weld the lowest coil and vibration coil 3 Install the battery and weld the fine and adverse (confirm that the battery should be powered before installation, and the major board could be charged and vibrated, with the minimal voltage between 3) Special precautions: 1 Please persist with the steps and don't set up the battery first Because the most important board of the battery is galvanized after it is installed, it is simple to burn the key board if you weld it again at this time 2 The externally heated electrical soldering iron can soften tin on the temperature Please pull out the plug of the soldering iron before welding Internally heated electrical soldering irons don't have to be unplugged (externally heated electrical soldering irons basically have leakage)

• 

Recenzja