Opisy

• How to use our wallpaper? STEP 1: Prepare the wall surface Your wall ought to be completely flat, clean and dry Levels rough surfaces, rough, holes and uneven spots Your wall ought to be a uniform color If not, you may word differences in coloration in your wall as soon as put in If your wall has a number of colors, we promote that you simply paint back Make a vertical line with a plumb line on the left edge of the world you would like cover with the mural If you've got a plumb, one can make your individual through tying a heavy object on the end of a rope This line is significant since it is the handbook to begin putting your mural STEP 2: Prepare the wallpaper The wallpaper panels are made with a width of 48 cm(19") Panels are received printed always on a roll and numbered on the height Cut self sustaining panels and do a preview at the ground following the numerical order from left to appropriate Measure with a meter the height of your wall If it&;s less than the photomural, you should cut it to slot wisely Do it when you have it at the floor yet go away a margin of an inch to correct any variations in point at the wall STEP 3: Prepare the glue You may well buy the glue from your supermarket, confirm it&;s for non-woven wallpaper use Prepare the glue following the directions on the bag of the glue you obtain Do it slowly So you'll achieve a uniform combination and without bubbles STEP 4: Attach the paper to the wall Applying glue at the wall flippantly using a broom or a paint curler Start distributing from the road you marked as a guide to the plummet Don&;t paste the whole wall, do it solely in the discipline that will disguise the 1st panel on the left, leaving a couple of inches exterior the right Apply the 1st panel of the mural at the wall starting on the top left Check that's aligned with the instruction manual Presses against the paper with a dry roller or sponge to remove any air bubbles Place the ensuing panels within the identical manner in numerical order The panels mustn't ever be fastened on one another but are set on edge Clean the excess glue with a damp sponge STEP 5: Finishing With the aid of a ruler and a cutter, modify the edges and the tip and backside of the wall if mandatory Let dry 24 hours; you'll get a perfect final result

• 
• 
• 
• 
• 

Recenzja