Opisy

• 12A 600W MPPT Solar Panel Charge Regulator Controller Board Lithium Battery Charging Board DC10-60V Solar Charge Controller Specifications: The maximum strength utilized by the photo voltaic panel: <600W (18V solar panel <200w, 36v solar panel <400w, whenever you paintings for a long time, please depart a margin for use, and listen in on the heat dissipation of the module) Input voltage: DC10-60V Input current: 12A MAX Input overcurrent protection: 12A MAX exceeding will robotically reduce the output voltage Output voltage: DC10-85V steplessly adjustable Output current: zero steplessly adjustable (the larger the output current, the larger the heat) MPPT voltage adjustable range: 10-60V steplessly adjustable Working frequency: 200KHz Working efficiency: The perfect 94% efficiency is expounded to enter and output voltage and dealing recent Applicable battery type: battery, polymer battery, iron lithium, and many others (adjust the output voltage and charging current in step with the battery) enter Anti-reverse connection protection: no Output anti-backflow: yes Short circuit protection: 15A fuse, (the output of the module cannot be immediately short-circuited, it'll burn the fuse or power tube!) Operating temperature: -20~+85℃, please upload a cooling fan when the temperature is excessive Dimensions: 76*60*56mm Weight: 210g Note: The precise parameters of voltage and recent can have a certain deviation due to the difference of elements parameters Steps for Adjusting Parameters of MPPT Boost Charging Module: 1 The module input is attached to the photo voltaic panel to make sure that the sun shines on the solar panel 2 The output of the module is no-load, and the voltage of the multimeter is hooked up to the output of the module, consistent with the voltage when the battery is entirely charged Voltage price (refer to the label on the back of the charger), adjust the CV potentiometer to the desired voltage Note: If the module would not boost, please turn the MPPT potentiometer 20 turns clockwise earlier than adjusting the output voltage three Connect the battery to the output of the module, and then join the voltage of the multimeter to the enter of the module Adjust the MPPT potentiometer to a multimeter exhibiting a voltage near to the maximum energy point voltage of the solar panel Refer to the utmost strength level voltage on the label on the again of the solar panel Generally, a lower voltage than the marked voltage can obtain a bigger charging current For example, if the MPPT cost of the 18V board is adjusted to 16-17V, the present could be larger than that of 18V You also can connect an ammeter in series to call again and forth the MPPT potentiometer to prevent the charging latest at the maximum point four If you should use a smaller current for charging (for example, the ability of the photo voltaic panel is comparatively large, and The battery means is comparatively small) When the sun is comparatively large, connect the present gear of the multimeter in collection between the MPPT charger and the battery, and alter the CC potentiometer to the required recent Notice: 1 The potentiometer used to adjust the parameters is multi-turn, and there are 28 turns from the minimal price to the maximum price Clockwise the voltage or latest will increase and counterclockwise decreases 2 If there is sun, the output voltage of the charger can't be adjusted, or the If the battery has no charging current, please turn the MPPT potentiometer clockwise for greater than 20 turns after which repeat step 3 three The input of MPPT charging module needs to be connected to battery or switching power supply for charging or boosting module time charge Please adjust the cC potentiometer per the extent of the output voltage to restrict the output latest to forestall over-power use, that will trigger the charger to overheat or burn the ability tube Package Included: 1*600W MPPT photo voltaic enhance controller LTC1871

• 
• 
• 
• 
• 

Recenzja